Commercial kitchen extract: getting the basics right

Home  /  Insights

A kitchen that breathes properly is safer, cooler and easier to run.

Commercial kitchen ventilation has one job that hides three: capture the heat, grease and combustion products at the cooking line; replace the huge volume of air you are throwing away; and do both without making the kitchen unbearable to work in or impossible to keep clean.

Capture starts with the canopy. It needs to overhang the cooking equipment properly and move enough air to hold the thermal plume, or smoke and grease simply roll out into the kitchen. Undersized canopies are the most common failure we see in kitchens that were fitted out on a budget.

Make-up air is the half that gets forgotten. A busy kitchen extract can move thousands of cubic metres per hour; if that air is not deliberately replaced, the kitchen pulls it through every door and gap in the building, doors slam, gas interlocks trip, and the extract never achieves its design rate. Every kitchen extract system should be designed as a pair: air out, air in.

Then there is the ductwork itself. Grease-laden extract duct needs to run to the discharge point with access panels for cleaning along the way - because grease deposits in an inaccessible duct are a fire risk sitting above a heat source. Cleanable duct routes are a design decision, not a maintenance afterthought.

Finally, interlocks and controls: gas supply interlocked to ventilation, sensible speed control for quiet periods, and a canopy that staff can actually clean at the end of service. None of this is exotic - it is the difference between a kitchen that passes its inspections quietly and one that collects enforcement letters.

If you are fitting out, refurbishing or inheriting a kitchen that never quite worked, we survey and price kitchen extract as a complete system - canopy, duct, discharge and make-up air together.

Talk to Us About Your Project